What are the characteristics of PVC mixing machine

When using a PVC mixing machine, a high-speed mixer or mixing unit is required in the early stage to mix PVC (soft PVC), dioctyl grease, DOP, stabilizer (calcium zinc heat stabilizer), lubricant, etc. according to the hardness of the pellets. After the required ratio, mix thoroughly.

●What are the characteristics of PVC mixing machine?

●What is the structure and performance of PVC mixing machine?

●What are the precautions for the use of PVC mixing machine?

What are the characteristics of PVC mixing machine?

1. The mixing barrel of the PVC mixing machine has three-dimensional motion in the X, Y, and Z directions. The material rotates, turns over, turbulence and shears in the container, so that the material does not accumulate during mixing, and the specific gravity is different. The mixing of materials of density and state does not produce the influence and deflection of centrifugal force;

2. The mixing time of PVC mixing machine is only 6-12 minutes/time;

3. The mixing uniformity rate of PVC mixing machine can reach more than 99%;

4. Low noise, low energy consumption, long life, small size, simple structure, easy operation and maintenance;

5. According to the material mixing requirements, the time relay can be adjusted to make reasonable use of the mixing time; while mixing with dry materials, it also has the function of timing and quantitative spray granulation device.

   
   

What is the structure and performance of PVC mixing machine?

The PVC mixing machine is mechanically driven and controlled by electrical circuits. The mixing part mainly has a driving shaft and a passive shaft. Each shaft has a universal joint. Between the two universal joints, there is a mixing barrel. The two shafts connected by the joints are spatially crossed and vertical, and respectively revolve around the active shaft and the passive shaft with the universal joint, and the movement of the mixing barrel makes the materials mix in the container.

When the PVC mixing machine is working, the mixing bucket has three-dimensional motion in the X, Y, and Z directions, and it also revolves while rotating. On the other hand, there is a turning movement, which overcomes the influence of centrifugal force, reduces the specific gravity segregation, and ensures uniform mixing.

What are the precautions for the use of PVC mixing machine?

1. The angle of the deflector of the high-speed mixer. The angle of the deflector determines the flow direction of the material when the high-speed mixer is running. If the deflector angle is not suitable, it is easy to cause: poor mixing uniformity, long mixing time, and mixing current. Great condition.

2. The discharge port of the high-speed mixer is sealed. After the discharge port of the traditional high-speed mixer is discharged, the discharge port is not tightly sealed due to the accumulation of materials. Causes the leakage of raw powder, the raw powder is doped in the mixed material, the reaction is not very obvious after granulation, but the crystal point is particularly obvious after the tube is pulled.

   
   

After reading, do you have a deeper understanding of PVC mixing machine? For further information, please contact Zhangjiagang YaTong Machinery Co., Ltd. They will be very pleased to help you!